Bnd-50 Se36 Instructions

The BND-50 SE36 (often listed as SG3 or similar variants) is a 7-day digital electronic power outlet timer.

1. Power on the device: Press the power button and wait for the device to boot up. The BND-50 SE36 will perform a self-test to ensure all systems are functioning correctly.
2. Select the operating mode: Choose the desired operating mode using the menu or control panel. Refer to the device's documentation or manufacturer's website for specific guidance on selecting the correct mode for your application.
3. Configure the device settings: Adjust the device settings according to your specific needs. This may include setting measurement units, selecting test parameters, or configuring data output options.
4. Take measurements or perform tests: Use the BND-50 SE36 to take measurements or perform tests according to your application's requirements. Ensure you follow proper technique and safety procedures to avoid damage to the device or injury to yourself.

3. Physical Installation Instructions

Step 1: Mounting the BND-50 SE36

The unit is designed for DIN rail mounting (TS35/7.5 or TS35/15). Follow these steps: bnd-50 se36 instructions

Continue holding CLOCK while pressing HOUR and MIN to set the current time of day. Programming: The BND-50 SE36 (often listed as SG3 or

Phase 3: PTZ Control (Data Connection)

If the SE36 is a PTZ (Pan-Tilt-Zoom) model, you must control it via RS-485. Power on the device : Press the power

Daylight Savings: Press HOUR and MIN (or CLOCK and WEEK) simultaneously to shift the time by one hour for summertime.

Introduction to the BND-50 SE36

Enter Programming Mode: Press the PROG button. The screen will display "1 ON". Set the "ON" Time: