E07-m1101d Pinout May 2026

The EBYTE E07-M1101D is a low-power, 433MHz wireless transceiver module based on the Texas Instruments CC1101 chip. It typically features an 8-pin DIP (Dual In-line Package) header with a 2.54mm pitch. Pinout Definition

General Purpose I/O – GDO0 and GDO2 (Pins 7 & 8)

These pins are highly configurable via CC1101 registers. Common uses: e07-m1101d pinout

| Pin | Name | Direction | Description | |-----|----------|-----------|-----------------------------------------------| | 1 | GND | Power | Ground (0V) | | 2 | VCC | Power | Power supply (1.8V – 3.6V DC) | | 3 | RXD | Input | UART Receive (Connect to TX of host MCU) | | 4 | TXD | Output | UART Transmit (Connect to RX of host MCU) | | 5 | AUX | Output | Indicator pin (Low = busy, High = ready/idle) | | 6 | M0 | Input | Mode setting pin 0 (Internal pull-down) | | 7 | M1 | Input | Mode setting pin 1 (Internal pull-down) | | 8 | RST | Input | Reset (Active low; pull high for normal run) | | 9 | NC | – | No connection (leave floating) | | 10 | GND | Power | Ground (0V) | | 11 | ANT | RF | Antenna (50Ω, usually via a hole/pad) | | 12 | GND | Power | Ground (0V) | The EBYTE E07-M1101D is a low-power, 433MHz wireless

2. The e07-m1101d Pinout Diagram

Below is the accurate pinout for the e07-m1101d as viewed from the top (component side) with the antenna pad or U.FL connector facing away from you. Common uses: | Pin | Name | Direction