Harvey Hv3 Water Softener Installation Manual Access

Harvey HV3 Water Softener Installation Manual: A Step-by-Step Guide

  1. Shut off the main water supply: Before you begin, locate the main water shut-off valve and turn it clockwise to shut off the water supply to your home.
  2. Choose a location for the water softener: Select a location for the water softener that is close to the point of entry for your home's water supply. The system should be installed on a level surface and have adequate drainage.
  3. Assemble the system: Attach the control valve to the resin tank, making sure to secure it tightly. Connect the brine tank to the control valve, following the manufacturer's instructions.
  4. Connect the distribution system: Connect the pipes and fittings to the control valve, resin tank, and brine tank. Make sure to follow the manufacturer's instructions for proper connection and configuration.
  5. Install the bypass valve: The bypass valve allows you to divert water around the water softener during maintenance or repair. Install the bypass valve according to the manufacturer's instructions.
  6. Connect the drain line: The drain line is responsible for removing wastewater from the system during the regeneration process. Connect the drain line to a suitable drainage location, such as a floor drain or sink.
  7. Program the control valve: Once the system is assembled and connected, program the control valve according to the manufacturer's instructions. This will ensure that the system is set to your specific water hardness levels and regeneration schedule.

Where to Find the Official HV3 Manual

Since Harvey no longer actively sells the HV3 (replaced by HV2 and HV4 in many markets), try these sources: harvey hv3 water softener installation manual

Accessibility: Leave enough slack in the hoses so the unit can be pulled out for maintenance. 3. The Bypass Valve Installation Shut off the main water supply : Before

Scan the unique QR code printed under the i-Lid label or enter the DSN/SSN manual codes. Where to Find the Official HV3 Manual Since

Installing a Harvey HV3 water softener involves placing the non-electric, twin-cylinder unit on a level surface, connecting it to the mains via a bypass manifold, and establishing proper drain and overflow lines. The installation requires 1–6 bar of pressure, with specialized kits for 15mm or 22mm pipes to manage inlet and outlet connections. For detailed technical guidance and installation procedures, consult the official documentation at Harvey Water Softeners.

Professional installation is recommended by Culligan Harvey to maintain warranty and prevent leaks, but it is often cited as DIY-friendly for those with plumbing knowledge.

Additional Resources:

  • Inlet = from main water supply
  • Outlet = to the house cold water system