Motorola Evx-261 Programming Software [new] 〈Firefox Reliable〉

Here’s a concise review of the Motorola EVX-261 programming software (often referred to as EVX-CLV or EVX Series Programming Software):

Analog Channel Setup:

1. Click on the "Zone/Channel Information" tab.
2. Select an empty channel (e.g., Channel 1).
3. Receive Frequency: Enter 464.500000
4. Transmit Frequency: Enter 464.500000 (or a repeater offset if used).
5. Channel Type: Select Analog.
6. Squelch Type: CTCSS (Continuous Tone-Coded Squelch System).
7. CTCSS Freq: Select 91.5 Hz (example tone—this must match your other radios).
8. Power: High (5W for UHF) or Low (1W for short-range).
9. Busy Channel Lockout: Enabled (prevents transmitting on an active frequency).

The radio beeped. The screen on the EVX-261 flickered to life: PROGRAM MODE. motorola evx-261 programming software

: Configure the 16 available channels to operate in either analog or digital mode. Button Mapping Here’s a concise review of the Motorola EVX-261

Note: Some users have successfully used generic USB-to-3.5mm "all-in-one" cables, though official Motorola/Vertex dealers recommend the FIF-12 for reliable firmware updates. Motorola EVX261 - Commercial Radios - Wireless Solutions Click on the "Zone/Channel Information" tab

Alternative: Some third-party USB-to-3.5mm cables integrate the electronics directly into the USB head, though official equipment is recommended for firmware updates. 2. Getting the CE156 Software

USB Interface Box: The FIF-12 USB Programming Interface acts as the bridge between the computer and the radio.